How can I install Home Security Motion Detector using ordinary eletrical outlet?
May 19, 2010 in
Home Security
I have a new Home Security Motion Detector that I plan to install in my driveway. The detector has white/black wires, but I only have a regular electric outlet that I can get power from. Is there a way to install it using my outlet ?
Disclaimer: Paid Affiliate site of Amazon.com.
Like this post? Subscribe to my RSS feed and get loads more!
4 comments
vladoviking on May 19, 2010 at 5:28 am
Yes you have the white conected to the common silfer
pcbeachrat on May 19, 2010 at 5:44 am
Simply go buy A plug end at any walmart…home depot etc and put it on the wires..On putting a plug end on something that light ..it dont really matter which side you puit the black or white wire on the plug end..very easy to do..Dont get one of them little cheap plug ends for 2.00..get a good heavier duty one for around 5.00..
analize2much on May 19, 2010 at 6:36 am
I will assume your oulet is outside. You can get an extension box and pipe up to where you want the light. Wire it in as normally would (white to white, black to black) Put oultel back in extension box. Hope this helps.
To answer this better you would have to give more detailed info.
Duchamp on May 19, 2010 at 7:15 am
The black wire is the power wire, the white one is neutral, and often there is a green ground wire. You also might consider adjusting the sensitivity of the detector to avoid lights being turned on by stray cats & such.